How to Use

• Usage
  Properly prepared exterior surfaces of wood, hardboard, aluminum siding, vinyl siding, masonry, brick, stucco, cement composition panels and metal. Not for use on floors.
• Prep
  Remove all surface contamination by washing with an appropriate cleaner, rinse throughly and allow to dry. Scrape and sand peeled or damaged paint to a sound surface. Sand glossy surfaces dull. Seal stains from water, smoke, ink, pencil, grease etc. with the appropriate primer/sealer. Caulk around windows, doows, and other openings.
• Application
  Stir paint thoroughly. Intermix containers for uniformity. When air temperature is 35°F, substrates may be colder. Prior to painting, check to be sure the air, surface, and material temperatures are above 35°F and at least 5°F above the dew point. Avoid using if rain or snow is expected within 1.5 hours. Do not apply when air or surface temperatures may drop below 35°F within 48 hours. On large expanses of metal siding, the air, surface, and material temperatures must be 50°F or higher. No reduction necessary. Apply with a nylon/polyester brush (like Purdy® XL®, a 3/8"- 3/4" nap synthetic roller cover (like Purdy® Marathon®), or airless spray (2000 psi, .015" - .019" tip).
• Dry Time
  Dry Time @ 77 °F and 50 % Relative Humidity
  To The Touch: 1 hour - 2 hour
  Recoat: 24 hour
• Clean-up & Disposal
  Clean spills, spatters, hands and tools immediately after use with soap and warm water. After cleaning, flush spray equipment with mineral spirits to prevent rusting of the equipment.